Before you try anything: always speak to a professional before cleaning, treating or applying any product to your stone. Every slab is different, and the wrong product can cause permanent damage. Contact us or a qualified stone restorer first.
Quick answer
Oil stains in granite need a solvent poultice: mix acetone or mineral turpentine with an absorbent powder, spread it over the stain, cover with plastic and leave it 24 to 48 hours. For fresh spills, sprinkle cornflour or talc on first to soak up as much oil as possible.
First, check what you are dealing with
- Darker, slightly translucent patch: oil. Follow the steps below.
- Dark patch that fades as it dries: water, not oil. Leave it to dry.
What you need
- Cornflour or talc
- Acetone or mineral turpentine
- Flour, talc or diatomaceous earth
- Plastic wrap and tape
- Plastic scraper
- Gloves
- Good ventilation
Step by step
Soak up fresh oil
If the spill is fresh, cover it with a thick layer of cornflour or talc and leave it for a few hours to absorb what it can, then brush it away.
Test first
Try the mixture on a hidden spot of your granite (inside a cut-out or under an overhang) and check the finish after it dries.
Mix the poultice
Stir an absorbent powder (plain flour, talc, diatomaceous earth or whiting) into acetone or mineral turpentine (open a window and keep flames away) until it has the consistency of peanut butter.
Apply it
Spread it 5 to 6 mm thick over the oil stain, extending about a centimetre past the edge. Resin-filled fissures in granite will not absorb much; concentrate on the stone around them.
Cover and wait
Cover with plastic wrap, tape the edges and poke a few small holes so it dries slowly. Leave it 24 to 48 hours until completely dry: the drying is what pulls the stain up into the powder.
Remove and rinse
Lift the dry poultice with a plastic scraper, rinse with clean water and dry the granite. If the oil stain is lighter but still there, repeat up to three times.
What not to use on granite
- Scourers, steel wool and abrasive creams on a polished surface.
- Mixing cleaning chemicals, especially bleach with anything else.
- Heat guns or hairdryers, which drive oil deeper.
- Scrubbing with degreasers, which spread the stain.
When to call a professional
Deep, old oil stains, or oil in resin-filled areas, are best left to a stone restorer. A stone restorer can re-polish granite with diamond pads and draw out deep stains.
Understanding oil and grease stains on granite
Granite porosity varies enormously: dense dark granites barely absorb anything, while light, coarse-grained granites soak up oil around the cooktop.
A stone restorer can re-polish granite with diamond pads and draw out deep stains.
Good to know
Oil stains are the most common problem on light granites around the cooktop. They show as darker, slightly translucent patches and usually lift with a solvent poultice.
Stop it happening again
Whether yours is light granites like Kashmir White and dense dark granites like Absolute Black, repairing it fixes today's mark; protecting it stops the next one. Our clear Stone Protection Film sits over the surface, so liquids cannot soak in. Choose Gloss for polished granite or Matte/Satin for honed and matte finishes. The protection is identical. It is installed across Sydney with a 10-year written warranty.
How we protect granite · Stain removal guide · Oil & grease stains on every surface